comp.lang.idl-pvwave archive: archive » Re: Is MAP procedure in IDL8.2 BROKEN?

Home » Public Forums » archive » Re: Is MAP procedure in IDL8.2 BROKEN?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Is MAP procedure in IDL8.2 BROKEN? [message #81460 is a reply to message #81459]

Fri, 21 September 2012 05:25

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

titan writes:

> I'm experiencing the following strange behavior of my IDL 8.2:
>
> If I would like to use the MAP procedure opening only IDL 8.2 it gives to me a syntax error (even when I'm using the example from IDL guide).
> But if I open ENVI+IDL (classic) then the procedure is compiled without problem.
>
> Is anybody facing the same problem??

Try putting a compile_opt idl2 statement in your
program.

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Re: Is MAP procedure in IDL8.2 BROKEN? By: David Fanning on Fri, 21 September 2012 06:08
		Re: Is MAP procedure in IDL8.2 BROKEN? By: titan on Fri, 21 September 2012 05:33
		Re: Is MAP procedure in IDL8.2 BROKEN? By: David Fanning on Fri, 21 September 2012 05:25

Previous Topic:	Is MAP procedure in IDL8.2 BROKEN?
Next Topic:	Plot Size difference

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 14:06:48 PDT 2025

Total time taken to generate the page: 0.56512 seconds