comp.lang.idl-pvwave archive: archive » extract ROI from contours with sub-pixel accuracy

Home » Public Forums » archive » extract ROI from contours with sub-pixel accuracy

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

extract ROI from contours with sub-pixel accuracy [message #81535]

Tue, 25 September 2012 22:28

suruchi
Messages: 13
Registered: September 2012

Junior Member

Hello
I have been able to extract ROIs from contour, but if i count the no of pixels it also includes pixels which are not fully covered in the contour.. hence for my set of images i have evolving contours.. but pixel count does not change because of this. Is there is way i can account for the pixel fraction covered in contour.. and take that information for my ROI area calculation..?
I don't wish to use 'perimeter area' since perspective correction is to be applied in the area calculation..using distance of pixels from the center of image.
Can i 'extract ROIs' too with sub-pixel information..?

Report message to a moderator

[Message index]

		extract ROI from contours with sub-pixel accuracy By: suruchi on Tue, 25 September 2012 22:28
		Re: extract ROI from contours with sub-pixel accuracy By: suruchi on Fri, 17 May 2013 23:39

Previous Topic:	strictarrsubs in IDL 8.1
Next Topic:	calling ANSYS Fluent from IDL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 07:07:56 PDT 2025

Total time taken to generate the page: 0.31990 seconds