comp.lang.idl-pvwave archive: archive » Re: How to correct errors an IDL

Home » Public Forums » archive » Re: How to correct errors an IDL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to correct errors an IDL [message #82372 is a reply to message #82371]

Sat, 08 December 2012 07:07

Dry in water
Messages: 18
Registered: October 2012

Junior Member

It can be read in ARCGIS but cannot be read in Matlab,too. Originally this image extracted from interpolation method in ARCGIS. I converted it into tiff file using ARCGIS as well. When I see the values of whole image by displaying values in command window of matlab, all values was -3.4028. Then I checked the values by subsetting 10-by-10 array. In this case, the values were correct.

Maybe it is not a proper tiff file. How can I ckeck or correct this?

Report message to a moderator

[Message index]

		Re: How to correct errors an IDL By: Dry in water on Sat, 08 December 2012 12:53
		Re: How to correct errors an IDL By: David Fanning on Sat, 08 December 2012 07:31
		Re: How to correct errors an IDL By: Dry in water on Sat, 08 December 2012 07:07
		Re: How to correct errors an IDL By: Mats Löfdahl on Sat, 08 December 2012 06:00
		Re: How to correct errors an IDL By: Mats Löfdahl on Sat, 08 December 2012 05:48
		Re: How to correct errors an IDL By: Helder Marchetto on Sat, 08 December 2012 05:44
		Re: How to correct errors an IDL By: Dry in water on Sat, 08 December 2012 04:12
		Re: How to correct errors an IDL By: Dry in water on Sat, 08 December 2012 02:55
		Re: How to correct errors an IDL By: Mats Löfdahl on Sat, 08 December 2012 00:57

Previous Topic:	Re: Some IDL8.2.1 Workbench related problems
Next Topic:	meanclip

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 04:39:27 PDT 2025

Total time taken to generate the page: 1.43800 seconds