comp.lang.idl-pvwave archive: archive » Using function after .reset

Home » Public Forums » archive » Using function after .reset

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Using function after .reset [message #82746 is a reply to message #82652]

Thu, 10 January 2013 10:32

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Paul Mallas writes:

> I use "compile_opt idl2" often and it is indeed used in the function that can't be found. But I will look around.

Coyote is always telling me to play the percentages when it comes to
women, tennis, and gambling. Bad advice, as always. :-(

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Using function after .reset By: PMan on Thu, 10 January 2013 09:47
		Re: Using function after .reset By: Matthew Argall on Mon, 14 January 2013 12:09
		Re: Using function after .reset By: David Fanning on Thu, 10 January 2013 10:32
		Re: Using function after .reset By: PMan on Thu, 10 January 2013 10:16
		Re: Using function after .reset By: David Fanning on Thu, 10 January 2013 10:11

Previous Topic:	equivalent width measurements
Next Topic:	Re: Error Handling Advice

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:25:09 PDT 2025

Total time taken to generate the page: 0.00411 seconds