comp.lang.idl-pvwave archive: archive » replacing "NAN" values using interpolation in IDL

Home » Public Forums » archive » replacing "NAN" values using interpolation in IDL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: replacing "NAN" values using interpolation in IDL [message #82952 is a reply to message #82789]

Tue, 29 January 2013 19:12

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Jeremy Bailin writes:

> I must admit, the silliness factor is the main reason I use the "data EQ
> data" convention. :-)

Ha, ha! I love this newsgroup. ;-)

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		replacing "NAN" values using interpolation in IDL By: abc on Thu, 17 January 2013 02:02
		Re: replacing "NAN" values using interpolation in IDL By: Carsten Lechte on Wed, 30 January 2013 01:18
		Re: replacing "NAN" values using interpolation in IDL By: Chang Liao on Thu, 11 April 2013 07:31
		Re: replacing "NAN" values using interpolation in IDL By: David Fanning on Tue, 29 January 2013 19:12
		Re: replacing "NAN" values using interpolation in IDL By: Jeremy Bailin on Tue, 29 January 2013 18:37
		Re: replacing "NAN" values using interpolation in IDL By: Dick Jackson on Tue, 29 January 2013 16:47

Previous Topic:	Re: SMOOTH not smoothing...
Next Topic:	Re: run-time function creation

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 09:42:32 PDT 2025

Total time taken to generate the page: 1.27844 seconds