comp.lang.idl-pvwave archive: archive » Re: Anstrom symbol not showing up on PS output

Home » Public Forums » archive » Re: Anstrom symbol not showing up on PS output

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Anstrom symbol not showing up on PS output [message #84075 is a reply to message #84012]

Thu, 25 April 2013 10:12

mairan.teodoro
Messages: 20
Registered: June 2008

Junior Member

Dear all,

I'm still having trouble to get the Angstrom symbol to show up properly on the PS/PDF output using Device Fonts (!P.FONT=0). I can achieve that if I set !P.FONT=1 just before the text command (I'm using CGTEXT), but the output will be quite different from what I'm using throughout the paper.

If I try to use the lower case Angstrom, everything is just fine, as one can see in this figure:

https://dl.dropboxusercontent.com/u/6573328/Angstrom_lowerca se.png

However, if I want to use the upper case Angstrom, which is the correct one, I think there is no room for the small circle to show up in the output for some reason that I don't know. See this figure:

https://dl.dropboxusercontent.com/u/6573328/Angstrom_upperca se.png

Is there any way of setting the size of the text window?

Thank you.

m.

Report message to a moderator

[Message index]

		Re: Anstrom symbol not showing up on PS output By: David Fanning on Wed, 24 April 2013 11:31
		Re: Anstrom symbol not showing up on PS output By: David Fanning on Wed, 24 April 2013 11:25
		Re: Anstrom symbol not showing up on PS output By: mairan.teodoro on Wed, 24 April 2013 11:17
		Re: Anstrom symbol not showing up on PS output By: David Fanning on Wed, 24 April 2013 11:16
		Re: Anstrom symbol not showing up on PS output By: mairan.teodoro on Wed, 24 April 2013 10:55
		Re: Anstrom symbol not showing up on PS output By: David Fanning on Wed, 24 April 2013 10:37
		Re: Anstrom symbol not showing up on PS output By: mairan.teodoro on Thu, 25 April 2013 10:12

Previous Topic:	Re: MAP_CONTINENTS,/HIRES does not match MAP_CONTINENTS,/HIRES,/USA
Next Topic:	Anstrom symbol not showing up on PS output

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 04:06:24 PDT 2025

Total time taken to generate the page: 1.28265 seconds