comp.lang.idl-pvwave archive: archive » Removing unwanted data from a structure

Home » Public Forums » archive » Removing unwanted data from a structure

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Removing unwanted data from a structure [message #84276 is a reply to message #84137]

Wed, 08 May 2013 11:49

cab581
Messages: 7
Registered: April 2013

Junior Member

On Wednesday, May 8, 2013 2:47:20 PM UTC-4, cab581 wrote:
> I'm back for more!
>
>
>
> I'm trying to sift through my data to remove unwanted values. Previously I was removing data as it read out of a file, so the code worked fine. Now It's a bit more complex.
>
>
>
> FOR I = 0, 17 DO BEGIN
>
> FOR J = 0, 99 DO BEGIN
>
> ind = where(STRUCT.(6)[J] GT MED[i,j], count)
>
> IF count NE 0 THEN STRUCT.(6)[ind] = !values.F_Nan
>
> MEAN[I,J] = MEAN(STRUCT.(6)[J], /double, /NAN)
>
> ENDFOR
>
> ENDFOR
>
>
>
> I have lots of data. I have two dimensions (altitude, J and 10 degree latitude bins, I) within each data set. I have calculated the median (MED) for each I,J section in the structure. I want run through every single point in all of my files and remove those that are greater than that median. The problem with what I have written is that (I think!) it's looking for where every value across the whole of STRUCT.(6) are greater than the median, not the individual values within STRUCT.(6)
>
>
>
> Thanks in anticipation

I should add that the 'files' that I want to compare to the median are in a structure, the same dimensions as that of the median.

Report message to a moderator

[Message index]

		Removing unwanted data from a structure By: cab581 on Fri, 26 April 2013 09:34
		Re: Removing unwanted data from a structure By: Jeremy Bailin on Fri, 10 May 2013 15:10
		Re: Removing unwanted data from a structure By: cab581 on Fri, 10 May 2013 10:41
		Re: Removing unwanted data from a structure By: Jeremy Bailin on Thu, 09 May 2013 16:13
		Re: Removing unwanted data from a structure By: cab581 on Wed, 08 May 2013 11:49

Previous Topic:	Q: project_vol
Next Topic:	MPFIT and bestnorm

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 22:04:29 PDT 2025

Total time taken to generate the page: 0.00222 seconds