comp.lang.idl-pvwave archive: archive » contour discontinuity

Home » Public Forums » archive » contour discontinuity

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: contour discontinuity [message #84389 is a reply to message #84237]

Tue, 28 May 2013 07:14

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Sam writes:

> Sorry David, I should have written more. My levels=findgen(7)*.5-3 and contour values are from -3.0 to +3.0. I want all the contours in the plot, but only labelling the zero contour without decimal.

I would say use two contour commands. One with the levels you want,
without the zero level, and the second as I showed you with the zero
level overplotted.

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		contour discontinuity By: Rosie on Fri, 03 May 2013 03:35
		Re: contour discontinuity By: David Fanning on Tue, 28 May 2013 08:20
		Re: contour discontinuity By: David Fanning on Tue, 28 May 2013 08:19
		Re: contour discontinuity By: Rosie on Tue, 28 May 2013 07:56
		Re: contour discontinuity By: Rosie on Tue, 28 May 2013 07:47
		Re: contour discontinuity By: David Fanning on Tue, 28 May 2013 07:14
		Re: contour discontinuity By: Rosie on Tue, 28 May 2013 07:05
		Re: contour discontinuity By: David Fanning on Mon, 27 May 2013 17:23

Previous Topic:	nested structures in dlm
Next Topic:	Re: Patagonia Trek

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 02:59:08 PDT 2025

Total time taken to generate the page: 0.48089 seconds