comp.lang.idl-pvwave archive: archive » contour discontinuity

Home » Public Forums » archive » contour discontinuity

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: contour discontinuity [message #84442 is a reply to message #84237]

Mon, 27 May 2013 17:23

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Sam writes:

> I want to label only zero contour.I used c_levels=[0,0,0,1,0,0,0] say for a total of 7 levels. Sometimes, there is a overlap of that 0 value. How to get rid of that? Moreover, if I want that label as only '0' rather than 0.0, can I do that?

data = cgdemodata(2)-750.0
cgContour, data, levels=0, c_annotation='0'

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		contour discontinuity By: Rosie on Fri, 03 May 2013 03:35
		Re: contour discontinuity By: David Fanning on Tue, 28 May 2013 08:20
		Re: contour discontinuity By: David Fanning on Tue, 28 May 2013 08:19
		Re: contour discontinuity By: Rosie on Tue, 28 May 2013 07:56
		Re: contour discontinuity By: Rosie on Tue, 28 May 2013 07:47
		Re: contour discontinuity By: David Fanning on Tue, 28 May 2013 07:14
		Re: contour discontinuity By: Rosie on Tue, 28 May 2013 07:05
		Re: contour discontinuity By: David Fanning on Mon, 27 May 2013 17:23

Previous Topic:	nested structures in dlm
Next Topic:	Re: Patagonia Trek

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:58:52 PDT 2025

Total time taken to generate the page: 0.00459 seconds