comp.lang.idl-pvwave archive: archive » Y-axis problems using cgcontour

Home » Public Forums » archive » Y-axis problems using cgcontour

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Y-axis problems using cgcontour [message #85765 is a reply to message #85764]

Wed, 04 September 2013 12:48

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Morgan Silverman writes:

> I'm trying to use cgcontour to plot a latitude altitude cross section of temperature data. My altitudes are actually pressure values and I need them to go from 1000mb to 10mb with 1000mb being at the bottom of the y-axis. I know how to do this using cgplot but I can't figure out how to do the same when using cgcontour. I also would like to have a log scale if possible for pressure. Is it possible to do this

Did you try reversing your Y vector?

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Y-axis problems using cgcontour By: morganlsilverman on Wed, 04 September 2013 12:42
		Re: Y-axis problems using cgcontour By: David Fanning on Wed, 04 September 2013 12:48
		Re: Y-axis problems using cgcontour By: David Fanning on Wed, 04 September 2013 12:57
		Re: Y-axis problems using cgcontour By: morganlsilverman on Wed, 04 September 2013 13:04
		Re: Y-axis problems using cgcontour By: Paul Van Delst[1] on Thu, 05 September 2013 07:51
		Re: Y-axis problems using cgcontour By: David Fanning on Thu, 05 September 2013 08:09

Previous Topic:	CgBarPlot with NaNs?
Next Topic:	overplots with two different y axes

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Thu Oct 09 02:47:07 PDT 2025

Total time taken to generate the page: 0.23857 seconds