comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado

Home » Public Forums » archive » display position arrays on an image
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend 
Return to the default flat view Create a new topic Submit Reply
Re: display position arrays on an image [message #88795 is a reply to message #88794] Fri, 20 June 2014 09:32 Go to previous messageGo to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
g.nacarts@gmail.com writes:

> I am using the tvscl command to display the image. But I tried the save command and I just had the position vectors. The image is not shown anywhere.
> My code was like this:
>
> cgDisplay, 550, 550
> cgimage, image, /save
> cgDrawVectors, x, y, pos_x, pos_y,fraction=0.001, /ORDERED
>

Try setting the SCALE keyword on cgImage.

Cheers,

David


--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thue. ("Perhaps thos speakest truth.")
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: read lambert projected image
Next Topic: IDL 8.2 IDL_IDLBridge & abortion

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 00:48:36 PDT 2025

Total time taken to generate the page: 1.84096 seconds