comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » read lambert projected image
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Return to the default flat view Create a new topic Submit Reply
Re: read lambert projected image [message #88799 is a reply to message #88798] Sat, 21 June 2014 09:56 Go to previous messageGo to previous message
audrey.schaufelberger is currently offline  audrey.schaufelberger
Messages: 10
Registered: June 2014
Junior Member
I am afraid I don't quite understand what you mean... I have an image showing the farside of the moon. The complete farside, so I know that the map ranges from 90...270 deg in longitude and from -90...90 deg in latitude. I also know that the projection used is a lambert equal area projection. In addition, the map fills the image, i.e., (90/0) deg touches the left center, (180/90) deg the top center, (270/0) deg the right center and (180/-90) deg the bottom center of the image. So in theory I guess, since everything seems well defined, I should be able to determine the lon/lat pair corresponding to a x/y image coordinate. I was hoping there was a procedure where I can tell what projection a map is plotted with, and the procedure would read the .jpg while assigning each x/y image coordinate the right lon/lat coordinate.
but that might be a bit much I ask for...

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: map_set without any grid lines
Next Topic: display position arrays on an image

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Nov 28 08:39:59 PST 2025

Total time taken to generate the page: 0.00982 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software