comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » NOCLIP in XYOUTS not working with !P.FONT
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Return to the default flat view Create a new topic Submit Reply
Re: NOCLIP in XYOUTS not working with !P.FONT [message #89676 is a reply to message #89675] Wed, 12 November 2014 05:28 Go to previous messageGo to previous message
David Fanning is currently offline  David Fanning
Messages: 11724
Registered: August 2001
Senior Member
Kaushal Sharma writes:

> In my plotting routine, if I am using !P.FONT=2 before the device command. Now when I use XYOUTS for labelling some data points with (NOCLIP=0,/DATA), it is still putting the labels for those points which are out of the plotting frame.
> But when I remove !P.FONT=2 at the starting of the programme, NOCLIP works fine. I don't know why NOCLIP is causing problem with !P/FONT.

I'm not sure what it means to set !P.Font=2, since the only values
officially "accepted" are -1, 0, and 1, but having NOCLIP unrecognized
when using true-type fonts (!P.Font=1) is probably a long-time bug in
IDL. I normally run into this the bug when doing map projections:

http://www.idlcoyote.com/map_tips/noclip.html

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: ignoring the strings
Next Topic: Three questions if you can please help

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Oct 10 05:39:51 PDT 2025

Total time taken to generate the page: 0.40474 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software