comp.lang.idl-pvwave archive: archive » making a rainbow colour plot.

Home » Public Forums » archive » making a rainbow colour plot.

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

making a rainbow colour plot. [message #91484]

Mon, 20 July 2015 09:10

Cibi Raj
Messages: 18
Registered: May 2015

Junior Member

Hey all, i am making a plot of pitch angle versus Eflux ( eV7sec/cm2/ster/ev) for the data obtained by Wind Spacecraft. it contains 9 plots ranging from high ev to low ev.I am using padplot_both.pro to get it:

my_padplot_both,pd,UNITS='flux',EBINS=[0L,8L]

I wanted to get it in colour, so i loaded the color table with loadact.pro following the above command:

UMN> loadct,39
% LOADCT: Loading table Rainbow + white
UMN> device,decomposed=0

But still I coulnt get the plot in colour. Where am I doing the mistake ?

Will be helpful. thanks in advance !

Report message to a moderator

[Message index]

		making a rainbow colour plot. By: Cibi Raj on Mon, 20 July 2015 09:10
		Re: making a rainbow colour plot. By: Cibi Raj on Mon, 20 July 2015 09:29
		Re: making a rainbow colour plot. By: Cibi Raj on Mon, 20 July 2015 11:24
		Re: making a rainbow colour plot. By: wlandsman on Mon, 20 July 2015 11:48
		Re: making a rainbow colour plot. By: Cibi Raj on Mon, 20 July 2015 12:33

Previous Topic:	Writing .mat files in IDL
Next Topic:	map projection

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 28 08:40:11 PST 2025

Total time taken to generate the page: 0.01614 seconds