comp.lang.idl-pvwave archive: archive » making a rainbow colour plot.

Home » Public Forums » archive » making a rainbow colour plot.

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: making a rainbow colour plot. [message #91491 is a reply to message #91484]

Mon, 20 July 2015 11:48

wlandsman
Messages: 743
Registered: June 2000

Senior Member

It is not clear from your question whether you are reloading the image after running loadct
LOADCT will not change the colors of any images that are already displayed.

http://www.exelisvis.com/Support/HelpArticles/TabId/185/ArtM ID/800/ArticleID/4287/4287.aspx

On Monday, July 20, 2015 at 12:10:38 PM UTC-4, Cibi Raj wrote:
> Hey all, i am making a plot of pitch angle versus Eflux ( eV7sec/cm2/ster/ev) for the data obtained by Wind Spacecraft. it contains 9 plots ranging from high ev to low ev.I am using padplot_both.pro to get it:
>
> my_padplot_both,pd,UNITS='flux',EBINS=[0L,8L]
>
> I wanted to get it in colour, so i loaded the color table with loadact.pro following the above command:
>
> UMN> loadct,39
> % LOADCT: Loading table Rainbow + white
> UMN> device,decomposed=0
>
> But still I coulnt get the plot in colour. Where am I doing the mistake ?
>
> Will be helpful. thanks in advance !

Report message to a moderator

[Message index]

		making a rainbow colour plot. By: Cibi Raj on Mon, 20 July 2015 09:10
		Re: making a rainbow colour plot. By: Cibi Raj on Mon, 20 July 2015 09:29
		Re: making a rainbow colour plot. By: Cibi Raj on Mon, 20 July 2015 11:24
		Re: making a rainbow colour plot. By: wlandsman on Mon, 20 July 2015 11:48
		Re: making a rainbow colour plot. By: Cibi Raj on Mon, 20 July 2015 12:33

Previous Topic:	Writing .mat files in IDL
Next Topic:	map projection

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 11:35:24 PDT 2025

Total time taken to generate the page: 0.00442 seconds