comp.lang.idl-pvwave archive: archive » How to overplot in log scale?

Home » Public Forums » archive » How to overplot in log scale?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: How to overplot in log scale? [message #93382 is a reply to message #93381]

Tue, 28 June 2016 08:44

Craig Markwardt
Messages: 1869
Registered: November 1996

Senior Member

On Tuesday, June 28, 2016 at 10:53:57 AM UTC-4, Meegle_Jade wrote:
> I used OPLOT procedure. But there was no log scale option there.

No need. OPLOT uses the existing plotting scale. If you PLOT'd with a logarithmic scale then OPLOT will re-use that scale.

If you are asking, how to you overplot logarithmic data points on an existing LINEAR plot, well that's a little more complicated.

Report message to a moderator

[Message index]

		How to overplot in log scale? By: Sonu Tabitha on Tue, 28 June 2016 07:53
		Re: How to overplot in log scale? By: Craig Markwardt on Tue, 28 June 2016 08:44
		Re: How to overplot in log scale? By: Sonu Tabitha on Wed, 29 June 2016 09:22

Previous Topic:	How to give values as a range in array?
Next Topic:	IDL: Extracting Bit values in VIIRS Aerosol product

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 20:06:37 PDT 2025

Total time taken to generate the page: 0.41977 seconds