comp.lang.idl-pvwave archive: archive » how to replace fits variable and store back into same fits file??

Home » Public Forums » archive » how to replace fits variable and store back into same fits file??

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: how to replace fits variable and store back into same fits file?? [message #93447 is a reply to message #93445]

Tue, 19 July 2016 09:42

Craig Markwardt
Messages: 1869
Registered: November 1996

Senior Member

On Tuesday, July 19, 2016 at 10:57:08 AM UTC-4, Sapna Mishra wrote:
> now I only want to change value of aa.FLUX.
> doing mwrfits,'spec.fits',aa,h as you suggested is changing value of all variables. Is any one getting my problem???

Did you change the values of any of the other columns stored in AA? If you did not make any changes to AA, then writing out with MWRFITS will just create a new file with the same column values you started with.

CM

Report message to a moderator

[Message index]

		how to replace fits variable and store back into same fits file?? By: Sapna Mishra on Tue, 19 July 2016 04:48
		Re: how to replace fits variable and store back into same fits file?? By: wlandsman on Tue, 19 July 2016 05:50
		Re: how to replace fits variable and store back into same fits file?? By: Sapna Mishra on Tue, 19 July 2016 07:57
		Re: how to replace fits variable and store back into same fits file?? By: wlandsman on Tue, 19 July 2016 08:07
		Re: how to replace fits variable and store back into same fits file?? By: Craig Markwardt on Tue, 19 July 2016 09:42

Previous Topic:	Plotting time as x-axis
Next Topic:	Poltting with TVSCL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 13:44:20 PDT 2025

Total time taken to generate the page: 0.88261 seconds