| Re: XYOUTS in 3D [message #83279] |
Tue, 12 February 2013 10:09 |
vlk.astro
Messages: 11
Registered: March 2006
|
Junior Member |
|
|
Doh! Thanks. For some reason that keyword was invisible to my eyes until you pointed it out!
On Monday, February 11, 2013 6:37:31 PM UTC-5, David Fanning wrote:
> vlk.astro@gmail.com writes:
>
>
>
>> Is there a way to specify a z-offset to XYOUTS?
>
>
>
> Z keyword. :-)
>
>
>
>> I have a complex set of PLOTS calls with /T3D set, and I want to label certain regions of the figure. Unfortunately, XYOUTS does not accept the Z-coordinate, so all the labels are stuck in the XY plane. Is there some alternative to XYOUTS (in IDL 7) that will achieve this?
>
>
>
> Use the Z keyword along with T3D.
>
>
>
> Cheers,
>
>
>
> David
>
>
>
> --
>
> David Fanning, Ph.D.
>
> Fanning Software Consulting, Inc.
>
> Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
>
> Sepore ma de ni thue. ("Perhaps thou speakest truth.")
|
|
|
|
| Re: XYOUTS in 3D [message #83290 is a reply to message #83279] |
Mon, 11 February 2013 15:37  |
David Fanning
Messages: 11724
Registered: August 2001
|
Senior Member |
|
|
vlk.astro@gmail.com writes:
> Is there a way to specify a z-offset to XYOUTS?
Z keyword. :-)
> I have a complex set of PLOTS calls with /T3D set, and I want to label certain regions of the figure. Unfortunately, XYOUTS does not accept the Z-coordinate, so all the labels are stuck in the XY plane. Is there some alternative to XYOUTS (in IDL 7) that will achieve this?
Use the Z keyword along with T3D.
Cheers,
David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")
|
|
|
|
comp.lang.idl-pvwave archive
Members
Search
Help
Login
Home
