comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Specifying horizontal contour labels
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Specifying horizontal contour labels [message #88686] Tue, 03 June 2014 05:58
Sir Loin Steak is currently offline  Sir Loin Steak
Messages: 42
Registered: January 2012
Member
Hi all,

I'm trying to label some contours, but IDL keeps putting the labels on vertical contour segments (I assume because these are the most 'straight'. Is there a way to tell contour that I want the labels to be horizontal? I'm guessing that this can probably only be done using object graphics, but thought I'd check just in case!

An example can be found here: http://physics.open.ac.uk/~lsteele/cont_label.png

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: stereo triangulation in IDL
Next Topic: Segmentation fault (core dumped)

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 15:06:07 PDT 2025

Total time taken to generate the page: 0.00538 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software