comp.lang.idl-pvwave archive: archive » interact with iimage from the command line?

Home » Public Forums » archive » interact with iimage from the command line?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

interact with iimage from the command line? [message #60472]

Tue, 20 May 2008 21:03

Keflavich
Messages: 19
Registered: May 2008

Junior Member

I'd like to use iimage to display some data that is extremely unwieldy
to direct display - I'm trying to show some 100x10,000 arrays. To
make this useable, I would like to resample the data or change its
aspect ratio to display more nicely. This can be done interactively
in iimage, but I couldn't find anything telling me how to get it to
happen from the command line. Can anyone tell me how to use this?
Better yet, can anyone point me to documentation on interacting with
iTools from the command line?

Thanks,
Adam Ginsburg

Report message to a moderator

Previous Topic:	Re: Help with getting rid of a FOR loop
Next Topic:	Least square fitting

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 03:33:55 PDT 2025

Total time taken to generate the page: 0.72999 seconds