comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » How to add a header/info file for a matrix to become a FITS file?
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
How to add a header/info file for a matrix to become a FITS file? [message #63329] Thu, 06 November 2008 05:06 Go to next message
Griffons is currently offline  Griffons
Messages: 15
Registered: November 2008
Junior Member
Hello Everyone,

Anyone would know how to add a known header/info files for a matrix to
become a FITS file?

Thank you.

Griffons

Report message to a moderator

Re: How to add a header/info file for a matrix to become a FITS file? [message #63481 is a reply to message #63329] Fri, 07 November 2008 16:49 Go to previous message
Jeremy Bailin is currently offline  Jeremy Bailin
Messages: 618
Registered: April 2008
Senior Member
On Nov 6, 8:06 am, griffon...@gmail.com wrote:
> Hello Everyone,
>
> Anyone would know how to add a known header/info files for a matrix to
> become a FITS file?
>
> Thank you.
>
> Griffons

Take a good look through the FITS-related routines in IDL Astronomy
library (http://idlastro.gsfc.nasa.gov/). You should be able to figure
out what you're looking for.

-Jeremy.

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: my favourite dot command
Next Topic: quantum visualizations using IDL

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Thu Oct 09 23:08:51 PDT 2025

Total time taken to generate the page: 1.12292 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software