comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Plotting 3-D irregular data.
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Switch to threaded view of this topic Create a new topic Submit Reply
Plotting 3-D irregular data. [message #841] Thu, 29 April 1993 10:34
jabarone is currently offline  jabarone
Messages: 15
Registered: May 1993
Junior Member
I posting this article to ask again about plotting 3-D irregular data.
I would like to thank all the people who responded to my last post. Most
of them suggested that I try to use the TRIANGULATE and TRIGRID procedures
to view my data. This doesn't seem to work very well in my case. Someone
suggested that I use the PLOT3d command, but I haven't been able to find
this command in the version of IDL I am using. I have however discovered
the command PLOTS which seems to be what I'm looking for. However, I can't
seem to figure out how to make it plot in 3-D coordinates. I've looked at
the help which says I need to set the T3D keyword and make sure that
!p.T3D = 1. I've tried this but nothing seems to work. Any suggestions?

Thanks in advance.

John Barone
jabarone@athena.mit.edu

Report message to a moderator

  Switch to threaded view of this topic Create a new topic Submit Reply
Previous Topic: A Lookup-table-ish problem
Next Topic: wrapper routines

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Sat Oct 11 10:05:50 PDT 2025

Total time taken to generate the page: 0.39826 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software