comp.lang.idl-pvwave archive: archive » Re: axis labels in SURFACE all wrong

Home » Public Forums » archive » Re: axis labels in SURFACE all wrong

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: axis labels in SURFACE all wrong [message #18599]

Wed, 19 January 2000 00:00

davidf
Messages: 2866
Registered: September 1996

Senior Member

Andrew (noymer@my-deja.com) writes:

> I am making some surfaces using the SURFACE
> command and the X axis label is vertical, as if
> it were the Z axis label, instead of running
> parallel to the axis. The Y axis label is OK,
> but it is too close to the axis.
>
> Has anyone encountered this before?

Ah, yes. Hardware fonts don't rotate in 3D space
for some inexpiable reason, even in PostScript
output. You will have to use either software
fonts (!P.Font=-1) or True-Type fonts (!P.Font=1).

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting
Phone: 970-221-0438 E-Mail: davidf@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		Re: axis labels in SURFACE all wrong By: davidf on Wed, 19 January 2000 00:00
		Re: axis labels in SURFACE all wrong By: davidf on Tue, 18 January 2000 00:00

Previous Topic:	Re: Dicom?
Next Topic:	Importing PV-Wave EPS files into frame

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:40:20 PDT 2025

Total time taken to generate the page: 0.00483 seconds