comp.lang.idl-pvwave archive: archive » Low quality with 'IDLgrClipboard' object

Home » Public Forums » archive » Low quality with 'IDLgrClipboard' object

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Low quality with 'IDLgrClipboard' object [message #30859]

Sun, 19 May 2002 08:55

Georg Wiora
Messages: 13
Registered: November 2001

Junior Member

Hi,

I tried to draw an IDLgrPlot object to an IDLgrClipboard object using
OClip->draw,oPlot,VECTOR=1

The clipboard contained an EMF/WMF graphics after that operation. But with the clipboard viewer and after inserting this object
into a graphics program, it looked quite blocky with big pixels. Obviously it was not inserted as a vector graphics, but as a
scalable bitmap.

Is that a documentation problem or am i using wrong parameters? The documentation says, that the graphics is converted to vector
primitives, but it does not look like that.
Increasing the resolution of the Clipboard object does only create finer lines, but not a higher resolution result.

Who knows about that?

Regards,

Georg Wiora
DaimlerChrysler AG
Research Center Ulm

Report message to a moderator

[Message index]

		Low quality with 'IDLgrClipboard' object By: Georg Wiora on Sun, 19 May 2002 08:55
		Re: Low quality with 'IDLgrClipboard' object By: Karl Schultz on Thu, 23 May 2002 15:11
		Re: Low quality with 'IDLgrClipboard' object By: Pavel A. Romashkin on Thu, 23 May 2002 08:31

Previous Topic:	Object programming with data...
Next Topic:	give me any advice on volume visualization

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:04:20 PDT 2025

Total time taken to generate the page: 0.00401 seconds