comp.lang.idl-pvwave archive: archive » Re: Object Graphics Printing

Home » Public Forums » archive » Re: Object Graphics Printing

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Object Graphics Printing [message #32627]

Fri, 25 October 2002 06:57

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Ben Tupper (btupper@bigelow.org) writes:

> Now, if I could just figure out how David's neat little fsc_plotwindow
> works!

Yeah, me too. :-(

Have you had a look at the FSC_SURFACE_PRINT module
in FSC_SURFACE? I want the printed version of the
window to have the same aspect ratio (I.e., look like)
the version on the display, so I muck around with the
printer aspect ratio, then set the view coordinates.

I'm not sure this is what you want, but it might
give you some ideas for your new BT_Config program. :-)

Cheers,

David

--
David W. Fanning, Ph.D.
Fanning Software Consulting, Inc.
Phone: 970-221-0438, E-mail: david@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		Re: Object Graphics Printing By: David Fanning on Fri, 25 October 2002 06:57
		Re: Object Graphics Printing By: btupper on Thu, 24 October 2002 16:51
		Re: Object Graphics Printing By: Rick Towler on Wed, 23 October 2002 09:50
		Re: Object Graphics Printing By: btupper on Mon, 28 October 2002 18:14

Previous Topic:	Re: about MIN of 2D array
Next Topic:	Masking using user defined ROIs

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Dec 01 20:21:51 PST 2025

Total time taken to generate the page: 3.53182 seconds