comp.lang.idl-pvwave archive: archive » Re: drawing a single point in 3-D

Home » Public Forums » archive » Re: drawing a single point in 3-D

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: drawing a single point in 3-D [message #33986]

Tue, 11 February 2003 11:03

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

lyubo (lzagorch@cs.wright.edu) writes:

> I'll go with the polyline. Thanks Rick.

Now wait a minute! I was going to suggest PolyLine,
but you had already ruled it out as impossible to
implement! :-)

Cheers,

David
--
David W. Fanning, Ph.D.
Fanning Software Consulting, Inc.
Phone: 970-221-0438, E-mail: david@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

		Re: drawing a single point in 3-D By: David Fanning on Tue, 11 February 2003 11:03
		Re: drawing a single point in 3-D By: lyubo on Tue, 11 February 2003 11:53
		Re: drawing a single point in 3-D By: Rick Towler on Tue, 11 February 2003 10:30

Previous Topic:	License options when starting IDL
Next Topic:	Re: License options when starting IDL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 18:52:58 PDT 2025

Total time taken to generate the page: 0.00460 seconds