comp.lang.idl-pvwave archive: archive » Re: Reading and writing DXF files

Home » Public Forums » archive » Re: Reading and writing DXF files

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Reading and writing DXF files [message #35405]

Wed, 28 May 2003 07:04

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Norbert Hahn (hahn@hrz.tu-darmstadt.de) writes:

> I need to read and possibly write DXF files (AutoCAD) from within IDL.
> Is there some routine that extracts geometry information from DXF files
> around? Are there better formats suited to get 3D geometry from AutoCAD
> to IDL (and back) ?

You can use the IDLffDXF object to read and create
DXF files. You are going to have to know a bit more
about DXF files than is in the documentation, I think,
to be able to use it successfully, but there you go. :-)

Cheers,

David

--
David W. Fanning, Ph.D.
Fanning Software Consulting, Inc.
Phone: 970-221-0438, E-mail: david@dfanning.com
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Toll-Free IDL Book Orders: 1-888-461-0155

Report message to a moderator

[Message index]

Re: Reading and writing DXF files

By: David Fanning on Wed, 28 May 2003 07:04

Previous Topic:	Reading and writing DXF files
Next Topic:	Re: Webcam and serial control

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 21:58:07 PDT 2025

Total time taken to generate the page: 0.72293 seconds