comp.lang.idl-pvwave archive: archive » How to use the SPAWN pipe?

Home » Public Forums » archive » How to use the SPAWN pipe?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

How to use the SPAWN pipe? [message #36497]

Mon, 22 September 2003 18:49

Ricard Marxer
Messages: 2
Registered: September 2003

Junior Member

Hi,

I want to use the SPAWN command in IDL, to run a program under Unix that
takes a long time to finish, but while it runs it prints information in the
screen. I would like to print this information in a WIDGET_LIST, so I
thought I would have to use the SPAWN command with the UNIT keyword and then
run a loop that will read from the pipe and add the information to the VALUE
of the list. This is not a problem, the problem is how to know that the
program has finished??? Because the last line of the program might change
in every execution.

Thanks,
Ricard

---
Outgoing mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.502 / Virus Database: 300 - Release Date: 18/07/2003

Report message to a moderator

[Message index]

How to use the SPAWN pipe?

By: Ricard Marxer on Mon, 22 September 2003 18:49

Previous Topic:	Mercator Map Projection Image and Contour "Bleeding" Problem
Next Topic:	Re: How to use the SPAWN pipe?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 18:34:56 PDT 2025

Total time taken to generate the page: 0.87819 seconds