| Re: top margin and !P.MULTI [message #2678] |
Wed, 24 August 1994 04:48 |
zawodny
Messages: 121
Registered: August 1992
|
Senior Member |
|
|
In article <Cv0A55.8nF@ireq.hydro.qc.ca> brooker@toka.ireq-ccfm.hydro.qc.ca writes:
> Folks:
>
> Say I want to put four plots on a page. Using !P.MULTI=[0,2,2]
> does this very nicely but now I also want to leave a two inch
> margin at the top of the page to write some text information
> after the plotting is finished. Any suggestions?
> Thanks -Peter Brooker
Well, I thought that this was supposed to make it into the IDL V3.6
manual, but I did not see it in the index. Use !x.omargin and
!y.omargin to set the "outside margin". This works just like
!x(y).margin except that it applies to the entire page. Therefore,
!p.multi plots along with any further manipulation of !x(y).margin
affect only what happens inside the box created by using !x(y).omargin.
You can then place you text at the top of the page in the usual ways.
--
Joseph M. Zawodny (KO4LW) NASA Langley Research Center
Internet: zawodny@arbd0.larc.nasa.gov MS-475, Hampton VA, 23681-0001
TCP/IP: ko4lw@ko4lw.ampr.org Packet: ko4lw@n4hog.va.usa
|
|
|
|
comp.lang.idl-pvwave archive
Members
Search
Help
Login
Home
