comp.lang.idl-pvwave archive: archive » Re: problem using p.multi in IDL 5.3/IRIX

Home » Public Forums » archive » Re: problem using p.multi in IDL 5.3/IRIX

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: problem using p.multi in IDL 5.3/IRIX [message #48100]

Tue, 28 March 2006 13:28

William C. Keel
Messages: 3
Registered: March 2006

Junior Member

Paolo Grigis <pgrigis@astro.phys.ethz.ch> wrote:
> Something like

> device,ysize=28,yoffset=1

> after the set_plot,'PS' command
> could solve your problem. The sizes are in cm, fit them to
> your paper size.

> Ciao,
> Paolo

(sound of hand slapping forehead) Thanks!! That did the trick. Looks
like the default ysize was just smaller than it was looking for
(I had tried setting to 24.0 at one point wtih no joy)

Now back to my next attempt at pre-empting a referee's comment...

Bill Keel

Report message to a moderator

[Message index]

		Re: problem using p.multi in IDL 5.3/IRIX By: William C. Keel on Tue, 28 March 2006 13:28
		Re: problem using p.multi in IDL 5.3/IRIX By: David Fanning on Tue, 28 March 2006 07:50
		Re: problem using p.multi in IDL 5.3/IRIX By: Paolo Grigis on Tue, 28 March 2006 07:35

Previous Topic:	Re: Removing repeating array values
Next Topic:	Re: how to use IDL performing the Canonical correlation analysis(CCA)?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 15:53:11 PDT 2025

Total time taken to generate the page: 0.00402 seconds