comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: PLOTS and color

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: PLOTS and color [message #3308]

Fri, 16 December 1994 15:35

weertj
Messages: 4
Registered: November 1994

Junior Member

In article <3cnv0n$h40@ncar.ucar.edu> cavanaug@uars2.acd.ucar.edu (Charles Cavanaugh) writes:

> Does anyone know how to get the PLOTS routine to use a given color? Specifically, when
> the device is in xor drawing mode?

If you are drawing in xor mode, the actual color index will be the
inverted value of the color which was already there, so in 8-bits: 255 gets 0
and %11100000 gets %00011111. So it is not easy to specify the color when in
the xor-mode. One possible soluction is to draw only to a few bitplanes by
using the command DEVICE, Set_Write_Mask.
For more info contact me at;

Jacco van Weert,
weertj@euronet.nl

R.I.F. , Leeuwarden, The Netherlands

Report message to a moderator

[Message index]

Re: PLOTS and color

By: weertj on Fri, 16 December 1994 15:35

Previous Topic:	How can I print large PS polygons from PV-WAVE?
Next Topic:	Is there any way to define an unsigned long array???

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 14:18:57 PDT 2025

Total time taken to generate the page: 1.04127 seconds