comp.lang.idl-pvwave archive: archive » IDL & iTools used as post-processor for other commercial software

Home » Public Forums » archive » IDL & iTools used as post-processor for other commercial software

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

IDL & iTools used as post-processor for other commercial software [message #50488]

Thu, 28 September 2006 12:12

mvukovic
Messages: 63
Registered: July 1998

Member

Yesterday I saw a presentation about Chemkin software (by Reaction
Design). This software was developed at Sandia, and then
commercialized. And something looked familiar:

iTools were used to show the simulation results.

Some of the other widgets used in pre-processing also had an IDL feel,
but I am not 100% certain.

So, there you have it. That's why IDL is pushing object graphics :-)

Mirko

Report message to a moderator

[Message index]

		IDL & iTools used as post-processor for other commercial software By: mvukovic on Thu, 28 September 2006 12:12
		Re: IDL & iTools used as post-processor for other commercial software By: Benjamin Hornberger on Wed, 04 October 2006 09:26

Previous Topic:	Re: IDL & iTools used as post-processor for other commercial software
Next Topic:	Re: IDL Segmentation Fault

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 28 11:32:28 PST 2025

Total time taken to generate the page: 1.28583 seconds