comp.lang.idl-pvwave archive: archive » Re: Map parameters for Eta/NAM model

Home » Public Forums » archive » Re: Map parameters for Eta/NAM model

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Map parameters for Eta/NAM model [message #50690]

Thu, 12 October 2006 14:53

K. Bowman
Messages: 330
Registered: May 2000

Senior Member

In article <1160688548.292645.13390@c28g2000cwb.googlegroups.com>,
kuyper@wizard.net wrote:

>> The Dx, Dy grid increment (at 25 deg north) was selected so that the grid
>
> The fact that the Dx, Dy increment listed above applies at 25 deg north
> implies that 25N was used as one of the standard parallels.
>
>> spacing would be exactly 12.000 km at 35 deg north; the intersection of 35N
>> &
>
> The fact that those Dx, Dy increments are not the same as the scale at
> 35N implies that 35N is not one of the standard parallels,

> Assuming that there is only one standard parallel, I tried
> STANDARD=[25]. It came out as a rectangle.

Dang, that was easy. Thanks.

I would swear that I had tried 25, but obviously I hadn't. Once I fixed a typo
in one of the coordinates, it worked even better. ;-)

Thanks again, Ken

IDL> NAM_CONIC
-133.459 12.1900 0.123940 0.251988
-152.878 54.5640 0.123937 0.893352
-49.4200 57.3280 0.788918 0.893355
-65.1270 14.3420 0.788928 0.251983

Report message to a moderator

[Message index]

		Re: Map parameters for Eta/NAM model By: K. Bowman on Thu, 12 October 2006 14:53
		Re: Map parameters for Eta/NAM model By: James Kuyper on Thu, 12 October 2006 14:29

Previous Topic:	Re: Is it possible to use wire mesh and display the surface as a solid at the same time?
Next Topic:	call_procedure with a dynamically created keywords list?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 28 09:49:30 PST 2025

Total time taken to generate the page: 0.00843 seconds