comp.lang.idl-pvwave archive: archive » adding columns to a binary table in a fits file

Home » Public Forums » archive » adding columns to a binary table in a fits file

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

adding columns to a binary table in a fits file [message #53155]

Mon, 26 March 2007 16:02

adamamiller
Messages: 1
Registered: March 2007

Junior Member

I'm trying to add new columns to a binary table inside a fits file.
Right
now the only way I can see to do this is to rewrite the entire fits
file.

I have tried googling 'add column fits file idl' and other similar
phrases
and all I have found is advice which says I should use READFITS and
FTBADDCOL, however, I don't think those will work in my case because I
have variable length binary tables. I have also asked many of the
local
idl experts and they too don't have any ideas about a good place to
start.

Report message to a moderator

[Message index]

adding columns to a binary table in a fits file

By: adamamiller on Mon, 26 March 2007 16:02

Previous Topic:	What Do IDL Programmers Read?
Next Topic:	Moving Average on Hyperspectral dataset

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 07:59:10 PDT 2025

Total time taken to generate the page: 0.00650 seconds