comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Antes de FAC Club

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Antes de FAC Club [message #53647]

Fri, 27 April 2007 10:24

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Folks,

Here is a question for those of you who haven't started
your FAC celebrating yet.

Suppose I have a surface that looks sort of like
cans of various radii stacked on top of one another.
Big cans on the bottom and progressively smaller
cans toward the top. But here is the thing, the
can tower sort of *lists* to one side, as if it were
thinking about toppling over.

What I would like to do is put this tower back in
the proper orientation, so that if I looked straight
down on it from the +Z direction on a line through
the center of the cans, I would see a sort of bulls-eye
pattern.

Any notion of how I might go about doing that?

Cheers,

David
--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

Antes de FAC Club

By: David Fanning on Fri, 27 April 2007 10:24

Previous Topic:	Re: tiff to eps
Next Topic:	error reading a large number of binary files

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:13:20 PDT 2025

Total time taken to generate the page: 0.00422 seconds