comp.lang.idl-pvwave archive: archive » How to use IDL to read a large file of Geotif format and then write to a new geotif-format file?

Home » Public Forums » archive » How to use IDL to read a large file of Geotif format and then write to a new geotif-format file?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

How to use IDL to read a large file of Geotif format and then write to a new geotif-format file? [message #57714]

Mon, 17 December 2007 22:19

chenshengbj
Messages: 1
Registered: December 2007

Junior Member

Hello,everyone,
this is my first time to post my question in the forum. As a
beginner in learning IDL, I found a difficulty in reading a large file
and write into a new file.My work is to read large file whose size if
about 10 GB. Will anyone tell me how to read a large file of Geotif
format and then write to a new geotif-format file with the projection
and coordination information from the sourc file?

Report message to a moderator

[Message index]

		How to use IDL to read a large file of Geotif format and then write to a new geotif-format file? By: chenshengbj on Mon, 17 December 2007 22:19
		Re: How to use IDL to read a large file of Geotif format and then write to a new geotif-format file? By: KRDean on Fri, 28 December 2007 22:24

Previous Topic:	Re: Where is the CVS plugin for the workbench?
Next Topic:	writing a structure on an HDF5 file

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 04:59:51 PDT 2025

Total time taken to generate the page: 0.64442 seconds