comp.lang.idl-pvwave archive: archive » Changing values of one image from ENVI

Home » Public Forums » archive » Changing values of one image from ENVI

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Changing values of one image from ENVI [message #62270]

Fri, 29 August 2008 08:20

txominhermos
Messages: 25
Registered: October 2005

Junior Member

Hello,
I would like to change some pixel values of one image loaded with
ENVI_OPEN_FILE, but I cannot load the entire image in memory (this is
a very big image).
What I do is to access and process some specific regions of the image
using ENVI_GET_DATA, by defining subsets in DIMS.
I really wonder if there is any keyword in the procedure
ENVI_WRITE_ENVI_FILE, or other procedure (something inverse to
ENVI_GET_DATA) to perform this, because the only choice that I know is
to load the whole image in memory in IDL and write it again.

Thanks

Txomin

Report message to a moderator

[Message index]

		Changing values of one image from ENVI By: txominhermos on Fri, 29 August 2008 08:20
		Re: Changing values of one image from ENVI By: Chris Jengo on Sun, 31 August 2008 21:56
		Re: Changing values of one image from ENVI By: txominhermos on Mon, 15 September 2008 02:23
		Re: Changing values of one image from ENVI By: jeffnettles4870 on Sun, 31 August 2008 17:07
		Re: Changing values of one image from ENVI By: Jonathan Greenberg on Sun, 31 August 2008 11:37
		Re: Changing values of one image from ENVI By: Chris Jengo on Sun, 31 August 2008 07:25
		Re: Changing values of one image from ENVI By: Chris Jengo on Sun, 31 August 2008 07:07

Previous Topic:	Maximum index for arrays?
Next Topic:	How do I return a 2d array in a system routine?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:19:28 PDT 2025

Total time taken to generate the page: 0.00477 seconds