comp.lang.idl-pvwave archive
Messages from Usenet group comp.lang.idl-pvwave, compiled by Paulo Penteado
Home » Public Forums » archive » Re: how to suppres warning
Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend  		Return to the default flat view Create a new topic Submit Reply
Re: how to suppres warning [message #62972] Wed, 22 October 2008 08:51 Go to previous message
pgrigis is currently offline  pgrigis
Messages: 436
Registered: September 2007
Senior Member
edward.s.meinel@aero.org wrote:
> On Oct 22, 10:18�am, David Fanning <n...@dfanning.com> wrote:
>> Ingo von Borstel writes:
>>> Actually I hoped
>>> to get a useful hint, especially as I knew you �as a usually very
>>> helpful person... :S
>>
>> If I knew a useful hint, I'd probably offer it. But all
>> that comes to mind is "fix the code". :-)
>>
>> Cheers,
>>
>> David
>> --
>> David Fanning, Ph.D.
>> Fanning Software Consulting, Inc.
>> Coyote's Guide to IDL Programming:http://www.dfanning.com/
>> Sepore ma de ni thui. ("Perhaps thou speakest truth.")
>
> If only control-o still worked...
What did it do?

Ciao,
Paolo

>
> Ed "I've been doing this too long" Meinel

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Re: QUESTION: is there a command in idl which could clean up memory pieces?
Next Topic: ITK Interface

-=] Back to Top [=-
[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Wed Oct 08 17:14:21 PDT 2025

Total time taken to generate the page: 0.00432 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.0.7.
Copyright ©2001-2013 FUDforum Bulletin Board Software