comp.lang.idl-pvwave archive: archive » reversing calculation order

Home » Public Forums » archive » reversing calculation order

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

reversing calculation order [message #4087]

Mon, 24 April 1995 00:00

rclark
Messages: 12
Registered: September 1992

Junior Member

I need to fill in some values for a vector from a recurrence relation.

V(0:N-1) = func(V(1:*)) ;I wish there was a shorthand for (*-1)

Where V(N) is the only value initially defined (Well actually it is
calculated from an ascending recurrence relation but the values of
V(0:N-1) from that step are of no further interest. The results of the
second recurrence are the ones returned.)

I know that ROTATE can be used to reverse the order of the vector for the
calculation, and then reverse them again to put it back in the right
order. But is it possible to eliminate these two reverse operations and do
the calculation in backwards direction? (no FOR loops, too slow!)

The vector is fairly short but this function will get called a lot.

Richard Clark
rclark@lpl.arizona.edu
--
Still working on the other 999 lines.

Report message to a moderator

[Message index]

		reversing calculation order By: rclark on Mon, 24 April 1995 00:00
		Re: reversing calculation order By: Fergus Gallagher on Thu, 04 May 1995 00:00
		Re: reversing calculation order By: amaravad on Fri, 05 May 1995 00:00

Previous Topic:	Envi ROI Spectral/Bandmath
Next Topic:	Is there an emacs mode??

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Oct 10 07:41:19 PDT 2025

Total time taken to generate the page: 1.52239 seconds