comp.lang.idl-pvwave archive: archive » Re: idlgrcontour and clip

Home » Public Forums » archive » Re: idlgrcontour and clip_planes ?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: idlgrcontour and clip_planes ? [message #65099]

Tue, 10 February 2009 14:34

ghgm2008
Messages: 17
Registered: December 2008

Junior Member

On Feb 10, 12:47 pm, David Fanning <n...@dfanning.com> wrote:
> ghgm writes:
>> Any info/advice on clipping the contours ? Is clip_planes the way to
>> go ? How on Earth does it work ? All I've managed to do so far
>> is make the contour plot disappear.
>
> One on my favorite stories of all time is "Directions"
> in the Barry Lopez collection _Desert Notes_, my favorite
> book of all time. Anyway, this reminds me of the story.
> Lopez would say, "You are almost half-way there. Press on." :-)
>
> Cheers,
>
> David
>
> --
> David Fanning, Ph.D.
> Coyote's Guide to IDL Programming (www.dfanning.com)
> Sepore ma de ni thui. ("Perhaps thou speakest truth.")

OK,

nice piece of non help ;o) - but it did work....

This gets the job done - it clips everything to the West of -135. and
everything East of -55.

map_contour -> SetProperty, clip_planes=[[-1.,0.,0.,-135.],
[1.,0.,0.,55.]]

It "kind of" makes sense but is making my head hurt a little (I know
I'm too precious).
Anyhow, following the logic of the 2 clip planes above I should be
able to work out other ones.

Err, thanks David.

Report message to a moderator

[Message index]

		Re: idlgrcontour and clip_planes ? By: ghgm2008 on Tue, 10 February 2009 14:34
		Re: idlgrcontour and clip_planes ? By: David Fanning on Tue, 10 February 2009 11:47
		Re: idlgrcontour and clip_planes ? By: David Fanning on Thu, 12 February 2009 07:53

Previous Topic:	Why plots shown on screen and postscript are different?
Next Topic:	How to display two images using tvscl

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 07:16:18 PDT 2025

Total time taken to generate the page: 0.55979 seconds