comp.lang.idl-pvwave archive: archive » Re: Is there a command which could tell a CDF file is good or not?

Home » Public Forums » archive » Re: Is there a command which could tell a CDF file is good or not?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: Is there a command which could tell a CDF file is good or not? [message #66127]

Mon, 20 April 2009 02:21

R.Bauer
Messages: 1424
Registered: November 1998

Senior Member

litongmu@gmail.com schrieb:
> Hi all,
>
> I am trying to run a code to deal with 1200 CDF files. However, some
> of them are not good files. When I use certain CDF commands to open or
> read them. IDL will return a error message and stop running. Now the
> problem is I have so many files. And I do not know which are good,
> which are bad. They all look the same size. But I can only tell when
> the code stop running. Therefore, I have to rerun the code again after
> deleting the bad file it picked out. So is there any command in IDL
> which could tell whether a CDF file is good or not. The important
> feature is that it can return results based on the judge. And it will
> not stop a program from running.
> Thanks in advance.
>
> Sincerely

can you share one of the "broken" files.

We have had some trouble in the past by a broken hard disk. Only small
sections of the netCDF file were corrupted.

cheers
Reimar

Report message to a moderator

[Message index]

		Re: Is there a command which could tell a CDF file is good or not? By: R.Bauer on Mon, 20 April 2009 02:21
		Re: Is there a command which could tell a CDF file is good or not? By: David Fanning on Sun, 19 April 2009 14:49

Previous Topic:	Is there a command which could tell a CDF file is good or not?
Next Topic:	Re: Reading in data question

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 28 18:22:53 PST 2025

Total time taken to generate the page: 0.56613 seconds