comp.lang.idl-pvwave archive: archive » Re: iTools -> IDL command line code?

Home » Public Forums » archive » Re: iTools -> IDL command line code?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: iTools -> IDL command line code? [message #67004]

Fri, 26 June 2009 05:22

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

scott writes:

> Given that I'm a complete IDL neophyte, I'm still getting acquainted
> with iTools and am kind of shaky as far as my coding goes for the
> command line. So is there a way to export all the parameters I have
> set up for an iPlot to the equivalent command line code?

No. In fact, iTools uses a completely different graphics system
(object graphics) than you typically use at the command line
(direct graphics), and the two are not at all compatible. (They
even require different kinds of graphics windows, and you can't
mix one with the other.)

Most people find iTools far too complex to program, although
writing programs that use the object graphics system is not
that hard, and is absolutely required if you want to do
something in 3D.

Cheers,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.dfanning.com/
Sepore ma de ni thui. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

Re: iTools -> IDL command line code?

By: David Fanning on Fri, 26 June 2009 05:22

Previous Topic:	Envi virtual machine
Next Topic:	Re: Orthorectifying Quickbird scenes with RPC files

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sat Oct 11 01:12:58 PDT 2025

Total time taken to generate the page: 0.55875 seconds