comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Slicer

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Slicer [message #4260]

Thu, 18 May 1995 00:00

miller
Messages: 12
Registered: July 1994

Junior Member

Can someone tell me what the difference between 'high side' and 'low side' is in
the slicer routine. I have not been able to determine a clear-cut explanation for
what either of these options will do when rendering a 3-D MRI data set.

Thanks in advance,

Dave Miller
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@

Work
Address: Dave Miller
Research Assistant I/Programmer
Department of Magnetic Resonance Imaging
University Hospitals of Cleveland
2074 Abington Rd.
Cleveland, Ohio 44106

Career interests include Biomaterials, Prosthetics, Orthotics, and Functional
MR Imaging.

Phone: (216) 844-8034
Fax: (216) 844-8062
MRI: (216) 844-7750

E-mail: miller@amber.uh.cwru.edu
@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@@ @@@@@@@@@@@@@@@@@@@@

Report message to a moderator

[Message index]

		Slicer By: miller on Thu, 18 May 1995 00:00
		Re: Slicer By: agraps on Mon, 17 February 1997 00:00
		Re: Slicer By: agraps on Mon, 17 February 1997 00:00
		Re: Slicer By: David Foster on Mon, 24 February 1997 00:00

Previous Topic:	solving alghorithm for gaus curves
Next Topic:	IDL: Center of Gravity Function

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 13:31:42 PDT 2025

Total time taken to generate the page: 0.00580 seconds