comp.lang.idl-pvwave archive: archive » Re: IDL set

Home » Public Forums » archive » Re: IDL set_plot

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: IDL set_plot [message #67938]

Fri, 04 September 2009 07:53

Maarten[1]
Messages: 176
Registered: November 2005

Senior Member

On Sep 4, 4:06 pm, David Fanning <n...@dfanning.com> wrote:
> Maarten writes:
>> There can be only one current graphics device at any time, and thus
>> you can generate only one PS file in one run. A possible solution is
>> to first run the inner loop, and then run the outer loop.
>
> I'm not exactly sure what "one run" means. It is true
> that PostScript files can only be generated one at a time,
> but if a "run" is an IDL program, you can generate as many
> as you like in that program, as long as you do it one at
> a time. You can also generate as many "pages" of PostScript
> output as you like in a single PostScript file.

Yes. Communication: missing one another's point as closely as
possible. (problem probably exists at the sender).

"One run" in the context here, I meant to say: if you want to jump
from one PS file to another, and alternate between the different files
at will, that is not possible. If you want to generate a large number
of PS files sequentially: go right ahead. Also adding pages to a PS
file: fine, but only to one PS file at any one time.

Maarten

Report message to a moderator

[Message index]

		Re: IDL set_plot By: Maarten[1] on Fri, 04 September 2009 07:53
		Re: IDL set_plot By: David Fanning on Fri, 04 September 2009 07:06
		Re: IDL set_plot By: Maarten[1] on Fri, 04 September 2009 06:25

Previous Topic:	Re: Is it possible to set a string to a veriable name?
Next Topic:	Re: BIL to BSQ in chunks

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 19:18:26 PDT 2025

Total time taken to generate the page: 0.00404 seconds