comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » Re: BSQ to BIL

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Re: BSQ to BIL [message #69576]

Sat, 06 February 2010 13:00

Maxwell Peck
Messages: 61
Registered: February 2010

Member

> a=isis_write, r_fid,filename + '_bil.cub'

Hi,

I'm not sure where ISIS_WRITE comes from (it's not an ENVI function as
far as i know), or what your actual error is, but it is unlikely it
will accept the r_fid keyword. You will probably need to use the
ENVI_GET_DATA function to put the band in an IDL variable and output
it from that. If there is a lot of data you may need to use tiling
(all in the ENVI Programmers guide).

Max

Report message to a moderator

[Message index]

		Re: BSQ to BIL By: Maxwell Peck on Sat, 06 February 2010 13:00
		Re: BSQ to BIL By: David Fanning on Fri, 05 February 2010 12:02
		Re: BSQ to BIL By: penteado on Mon, 08 February 2010 12:53
		Re: BSQ to BIL By: jtmcahill on Mon, 08 February 2010 08:01

Previous Topic:	Shout Out to Mark Hadfield
Next Topic:	oplot

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 11:32:50 PDT 2025

Total time taken to generate the page: 0.00423 seconds