comp.lang.idl-pvwave archive: archive » fitting with asymmetric errors?

Home » Public Forums » archive » fitting with asymmetric errors?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

fitting with asymmetric errors? [message #74285]

Fri, 07 January 2011 08:46

Elizabeth
Messages: 1
Registered: January 2011

Junior Member

Hi all,
I'm trying to fit a curve to a data set with asymmetric errors. I
usually use mpfitexpr when fitting, but cannot see a way to input
anything other than symmetric errors (though this is could well be a
problem with my understanding rather than the routine!). If mpfitexpr
is not the task for the job, is there another routine you would
suggest?

Thank you very much for your time! :)
Liz

Report message to a moderator

[Message index]

fitting with asymmetric errors?

By: Elizabeth on Fri, 07 January 2011 08:46

Previous Topic:	IDL 8, EPS vs. PS graphics
Next Topic:	Re: IDL 8, EPS vs. PS graphics

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Wed Oct 08 17:38:05 PDT 2025

Total time taken to generate the page: 0.00444 seconds