comp.lang.idl-pvwave archive: archive » Using PS_START to create A4 Landscape postscript?

Home » Public Forums » archive » Using PS_START to create A4 Landscape postscript?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Using PS_START to create A4 Landscape postscript? [message #77890]

Thu, 29 September 2011 04:14

rjp23
Messages: 97
Registered: June 2010

Member

Hi,

I'm sure this is simple but I can't quite get it to work.

I want to create an A4 landscape postscript file where the plot takes
up the entire window (i.e. no margins).

I thought I could do this: PS_Start, FILENAME='plot.ps', chasize=1,
landscape=1, page='A4' but it doesn't seem to work.

I specifically don't want to use the psconfig GUI as this needs to run
in a loop and create multiple plots, but I thought I could set the
keywords in ps_start without needing to use ps_config.

Can someone point me in the right direction?

Cheers

Rob

Report message to a moderator

[Message index]

Using PS_START to create A4 Landscape postscript?

By: rjp23 on Thu, 29 September 2011 04:14

Previous Topic:	Is there a work around to save multiple variables with same head but different tails without listing all of them?
Next Topic:	Re: Is there a work around to save multiple variables with same head but different tails without listing all of them?

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Tue Dec 02 10:36:09 PST 2025

Total time taken to generate the page: 0.00968 seconds