comp.lang.idl-pvwave archive: archive » How to determine if ENVI is loaded?

Home » Public Forums » archive » How to determine if ENVI is loaded?

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

How to determine if ENVI is loaded? [message #78157]

Tue, 25 October 2011 09:15

Robin Wilson
Messages: 40
Registered: August 2010

Member

Hi,

I have a function which uses one of the commands provided by ENVI (for
example, ENVI_SELECT). If I call the function and ENVI is not loaded
then I'd like the function to load ENVI and then run the ENVI_SELECT
command, but if ENVI is already loaded I just want it to run the
ENVI_SELECT command.

Thus, I need some way to determine if ENVI is currently running in the
IDL session. Is there an official way to do this? Does ENVI set any
variable when it starts up?

I know (from the output of the help command) that when ENVI is running a
lot of specific ENVI procedures and functions are compiled - is there
some way to programmatically determine whether a function is compiled?

Any other ideas?

Cheers,

Robin
------------------
Robin Wilson
A PhD student studying complexity in remote sensing
www.rtwilson.com/academic

Report message to a moderator

[Message index]

How to determine if ENVI is loaded?

By: Robin Wilson on Tue, 25 October 2011 09:15

Previous Topic:	Re: Add a new variable to netCDF file?
Next Topic:	Help about IDL

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Mon Dec 01 11:45:40 PST 2025

Total time taken to generate the page: 0.01337 seconds