comp.lang.idl-pvwave archive: archive » Another IDL 8.2 Workbench Problem

Home » Public Forums » archive » Another IDL 8.2 Workbench Problem

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

Another IDL 8.2 Workbench Problem [message #82618]

Thu, 03 January 2013 09:36

David Fanning
Messages: 11724
Registered: August 2001

Senior Member

Folks,

I am running into another IDL 8.2 Workbench issue this morning.

I'm trying to debug a program, so I have put a breakpoint
in a drawing program. As I step though, I get to a long
FOR loop, which I would like to skip over. I set the
cursor to the first line of code after the FOR loop,
and choose "Run to Line" (Cntl-R). The code executes,
and I am located on the right line.

But, now I can no longer step though my code! The F6
key no longer works and the Step In, Step Over, Step Out,
and Skip keywords are grayed out in the Run menu. Sigh...

Any ideas how to get my debugging capabilities back?

Thanks,

David

--
David Fanning, Ph.D.
Fanning Software Consulting, Inc.
Coyote's Guide to IDL Programming: http://www.idlcoyote.com/
Sepore ma de ni thue. ("Perhaps thou speakest truth.")

Report message to a moderator

[Message index]

		Another IDL 8.2 Workbench Problem By: David Fanning on Thu, 03 January 2013 09:36
		Re: Another IDL 8.2 Workbench Problem By: David Fanning on Tue, 08 January 2013 10:12
		Re: Another IDL 8.2 Workbench Problem By: Brian Daniel on Tue, 08 January 2013 10:07

Previous Topic:	how to over plot after using "cgZplot"
Next Topic:	Re: how to over plot after using "cgZplot"

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Sun Oct 12 04:17:59 PDT 2025

Total time taken to generate the page: 0.40125 seconds