comp.lang.idl-pvwave archive: archive

Home » Public Forums » archive » XYOUTS in 3D

Show: Today's Messages :: Show Polls :: Message Navigator
E-mail to friend

XYOUTS in 3D [message #83292]

Mon, 11 February 2013 14:28

vlk.astro
Messages: 11
Registered: March 2006

Junior Member

Hello,

Is there a way to specify a z-offset to XYOUTS?

I have a complex set of PLOTS calls with /T3D set, and I want to label certain regions of the figure. Unfortunately, XYOUTS does not accept the Z-coordinate, so all the labels are stuck in the XY plane. Is there some alternative to XYOUTS (in IDL 7) that will achieve this?

If not, is there some way to convert an (x,y,z) plotted with PLOTS,/T3D into device or normal coordinates?

Thanks much,
Vinay

Report message to a moderator

[Message index]

XYOUTS in 3D

By: vlk.astro on Mon, 11 February 2013 14:28

Previous Topic:	Function compiles (maybe) but cannot be called
Next Topic:	Antidote to Doom and Gloom

-=] Back to Top [=-

[ Syndicate this forum (XML) ] [

] [

]

Current Time: Fri Nov 28 09:29:18 PST 2025

Total time taken to generate the page: 0.00818 seconds